Test cut 3/4 inch steel plate. Cut with the powermax 125

 The photo above shows the height adjustable heavy duty rollers that will aliow you to cut profiles in I beams and box beams. The photo below shows the  removable sections in place with the rollers.

Note in the back ground the 5 x 10 table has been working for them for the last 5 years and prompted the order for the 6 x 30 plasma table. 

The gantry will open and close the exhaust panels as it passes. You can see this in the photo on the right.

3/7/2017 the 6 x 33 plasma table was delivered to the customer

You can clearly see the exhaust panels that run all the way down the table.

Test cut 1 inch steel plate. Cut with the powermax 125

The table is now set in place.

ARK PLASMA

This plasma table is in the middle of construction. The table size is 6 x 30  heavy duty it will have removable sections in the middle of the table so the it will accept a 26ft steel I beam. The table will have exhaust panels all the way down the table at each section. The exhaust system will come on automatic. ( please see photo below )

Exhaust Panels

The customer has had this 6 x 30 ft  plasma table for a few weeks. The customer sent these photos of the plasma table cutting 5 x 30 ft steel plate by 1" material. With no problem. Power by the powermax 125. The exhaust works so good that no smoke is getting into the shop.